SWAROVSKI Electrical – Submitted Reports |

BACK TO ALL ENTRIES

Which Company are you working for?

Sturdie Trade Services

Which Trade are you working for?

Electrical

State

VIC

Date of Visit

02/08/2019

Technician's Name

Nathan McBain

Built Job Number

42167

Swarovski Site in VIC

eastland

Test Period

6 Monthly (90 minutes)

Push Button Test

Carry out push button test for correct operation

RCD Details (6 Month)

Distribution Board No.	Circuit No.	Push Button (YorN)	Pass / Fail (PorF)
T2122 DB	2	Y	P
T2122 DB	3	Y	P
T2122 DB	4	Y	P
T2122 DB	5	Y	P
T2122 DB	6	Y	P

Exit/Emergency Light Checklist

Check there has been no power interruption for at least 16 hours prior to test
Carry out discharge test to ensure the luminaries remain illuminated for the required in service duration (90 or 120 minutes)
Re-instate power to luminaries and check that the battery charge operation indicatior functions correctly
Report any failures and provide costing to rectify (where applicable)

Is there an Emergency Light Test Facility & is it labelled properly?

Timers

Check timers for correct operation and timing

EMERGENCY LIGHTS

Distribution Board No.	ID No.	Surface mounted or recessed? (SorR)	Lamp OK? (YorN)	Battery OK? (YorN)	Condition OK? (YorN)	Pass / Fail (PorF)	Fault	Repaired on Site (YorN)	Under Warranty (YorN)
T2122 DB	EM01	R	Y	Y	Y	P
T2122 DB	EM02	R	R	Y	Y	Y	P

EXIT LIGHTS

Distribution Board No.	ID No.	Lamp OK? (YorN)	Battery OK? (YorN)	Condition OK? (YorN)	Pass / Fail (PorF)	Fault	Repaired on Site (YorN)	Under Warranty (YorN)
		Y	Y	Y	P

General Checklist

Check correct operation of all luminaries
Report on any faulty luminaries/control gear
Provide costing to repair/replace

Are there accurate switchboard legends within each switchboard? Please take a photo send with report to epm@builtelectrical.com.au

Yes

If Yes, please upload all copies of legends here... (Limit of 6 megabytes total)

Switched Socket Outlets

Carry out visual check on SSOs for signs of misuse, blackening or deterioration
Check and report any outlets with multiple power boards overloading
Ensure any power boards used have an integral over-current limiter

Window Display Boxes - Is the Cabling in good conditions?

Yes

Are there any Warranty items needing to be repaired?

Paint & surfaces are clean?

Yes

Comments

LARGE AMOUNT OF CRACKS IN PLASTER ON WALLS AND CEILING

Fixture draws able to open and close freely?

Comments

LARGE BOTTOM SLIDING DRAW, REAR WALL UNDER VISUAL DISPLAY RHS HAS COME OFF SLIDING RAIL

GLASS WALL MOUNTED BOX NEXT TO REAR VISUAL DISPLAY RHS. BOX BASE THAT IS ATTACHED TO WALL BASE DROPPED AND STOPPED LOCK LOCKING AS IT NO LONGER REACHES LOCKING MECH HAS IT HAS DROPPED

Locks work on all fixtures?

Yes

Is there chips, dents or defects to joinery?

Is there damage to skirtings?

Comments

STAFF REPORTED EXPANSION JOINT THAT RUN LENGHT OF SHOP ON FLOOR IS A TRIPPING HAZARD AND HEELS ON SHOES GET CAUGHT

General cleanliness of fixtures, ceilings, P.O.S - provide details

Good

Any issues found onsite please take photos and upload here